TM-9-2350-261-34 Direct and General Maintenance Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 133 of 788
TM 9-2350-261-34 BLOCK POWER PLANT — Continued 0015 00 4. Stack a 4 x 6 x 10 inch (10 x 15 x 25 cm) block (1), a 2 x 4 x 10 inch (5 x 10 x 25 cm) block (2), and a 1 x 4 x 10 inch (3 x 10 x 25 cm) block (3) under transmission side of transfer gearcase. Blocks should be 8 inches (20 cm) high. 5. Stack a 4 x 6 x 18 inch (10 x 15 x 46 cm) block (4) and a 2 x 4 x 18 inch (5 x 10 x 46 cm) block (5) under rear of engine. Blocks should be about 7 inches (16 cm) high. 6. Lower power plant slowly down onto blocks. Check that power plant is firmly supported by the blocks. 7. Cover air inlet housing (6). Use wiping rag. FOLLOW-THROUGH STEPS 1. Install power plant in carrier (see your -20). END OF TASK 0015 00-3/4 blank