TM-9-2350-261-20-4 Unit Maintenance Manual Volume 4 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 628 of 788
TM 9-2350-261-20-4 MAINTENANCE ALLOCATION CHART (MAC)—Continued 0779 00 0779 00-28 EQUIPMENT REF CODE MAINTENANCE LEVEL NOMENCLATURE NATIONAL STOCK NUMBER TOOL NUMBER 11 H INSTALLER BODY, INJECTOR: USED W/4940-00-711-1919 INSTALLER BODY TO INSTALL INJECTOR TUBE 4940-00-711-1918 10881893 12 H INSTALLER PILOT, INJECTOR: USED W/4940-00-711-1918 INSTALLER BODY TO INSTALL INJECTOR TUBE 4940-00-711-1919 10881896 13 H INSTALLER FLARING DIE, INJECTOR: USED W/4910-00-711-1918 TO FLARE SMALL END OF INJECTOR TUBE 4940-00-711-1920 10881892 14 H REMOVER, CYLINDER LINER 5120-00-937-6140 J-22490 15 H EXPANDER, FRONT OIL SEAL: USED TO EXPAND CRANKSHAFT FRONT OIL SEAL WHEN INSTALLING ENGINE LOWER FRONT COVER 4910-00-591-6640 10949378 16 H EXPANDER, REAR OIL SEAL: USED TO EXPAND REAR OIL SEAL 5120-00-918-0587 KM-J-9769 17 F HOOK, LIFTING: USED TO LIFT FLYWHEEL 4910-00-722-3877 10881880 18 H STUD, FLYWHEEL ALINING: USED TO ALIGN FLYWHEEL HOUSING OR ENGINE LOWER FRONT COVER 5120-00-872-6015 KM-J-7540 19 H CLAMP SET, HOLD DOWN CYLINDER: USED TO LOCATE CYLINDER LINES WHEN INSTALLING PISTONS 5120-00-999-8618 J-21793-01 20 H COMPRESSOR, PISTON RING: USED TO COMPRESS PISTON RINGS WHEN INSTALLING PISTON IN CYLINDER LINER 5120-00-901-8651 KM-J-6883-01 21 H REMOVER AND REPLACER: USED TO REMOVE AND REPLACE PISTON RINGS 5120-00-494-1846 KM-J-8128 22 H REPLACER, PISTON PIN RETAINERS: USED TO REPLACE PISTON PIN RETAINERS 5120-00-733-8874 10881874