TM-9-2350-261-20-4 Unit Maintenance Manual Volume 4 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 383 of 788
TM 9-2350-261-20-4 REPLACE SMOKE GENERATOR ARMOR (M1059 ONLY) — Continued 0713 00 INSTALLATION WARNING Hanging loads, heavy parts, and overhead equipment can fall unexpectedly and kill or injure you. Stay clear of hanging loads, heavy parts, and overhead equipment. Use correct lifting devices. Always have helper guide heavy parts and equipment. 1. Install outboard armor shield. Have helper assist. a. Install eyebolt (1), washer (2), new lockwasher (3), and nut (4). b. Install outboard shield (5) on hull. Secure with ten screws (6) and washers (7). 2. Install inboard armor shield. Have helper assist. a. Position three hinges (8) and shims (9) on hull and secure with six screws (10) and washers (11). TIGHTEN SCREWS TO 51-54 LB-FT (68-73 N·M) TORQUE. Use torque wrench. b. Position two angle brackets (12) on shield (13). Secure with four screws (14) and washers (15). If necessary, add shims (16). TIGHTEN SCREWS TO 22-24 LB-FT (28-33 N·M) TORQUE. Use torque wrench. c. Install armor shield (13) in three hinge assemblies (8). Secure with three screws (17), new locknuts (18), and six washers (19). d. Raise armor shield (13). Secure with two screws (20) and washers (21) to angle brackets (22). TIGHTEN SCREWS TO 54-59 LB-FT (73-80 N·M) TORQUE. Use torque wrench. 0713 00-3