TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 75 of 936
TM 9-2350-261-20-3 REPLACE FLOOR PLATES (M1064 ONLY) — Continued 0437 00 INSTALLATION WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 1. If pads (19) through (23) or seals (24) and (25) were rem oved, apply l ight coat of adhesive to crossm em ber mating surfaces. Allow surfaces to becom e tacky. Install pads and seals on c rossmenbers and p ress su rfaces together firm ly. 2. Install guard (18), two screws (17), washers (16), and new locknuts (15) on rear floor plate (14). 3. Place rear floor plate (14) in carrier. Secure with two lined washers (13) and screws (12). 4. Place left front floor plate (11) and right front floor plate (10) in carrier. Secure with nine lined washers (9), one screw (8), and eight eyebolts (7). 5. Install guard (3) on hull with screw (4), washer (5), and new locknut (6). 6. Install screw (1) and washer (2) on guard (3). FOLLOW-THROUGH STEPS 1. Install personnel heater floor duct, if removed. (WP 0617 00). 2. Raise and lock ramp (see your -10). END OF TASK 0437 00-3/4 blank