TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 72 of 936
TM 9-2350-261-20-3 REPLACE REAR FLOOR PLATES (M113A2 AND M577A2 ONLY) — Continued 0436 00 INSTALLATION WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 1. If pads (6) and (7), strips (8), or seals (9) and (10) were removed, apply thin coat of adhesive to roughened side of rubber surface. Allow to dry 20-40 minutes. Apply thin coat of adhesive to metal surface of hull crossmembers. Allow to dry 30-120 seconds. Install new pads, strips, and seals on crossmembers and press surfaces together firmly. 2. Place rear floor plate (5) and two front floor plates (3) and (4) on hull crossmembers. Secure to hull with 16 lined washers (2) and screws (1). FOLLOW-THROUGH STEPS 1. Install personnel heater floor duct, if removed (WP 0617 00). 2. Raise and lock ramp (see your -10). END OF TASK 0436 00-2