TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 577 of 936
TM 9-2350-261-20-3 REPLACE RAMP DOOR HANDLES AND SHAFT — Continued 0569 00 ADJUSTMENT NOTE When adjusted properly, door handle will have no end play. Ramp door should be flush with ramp in the closed position. 1. Remove handles (1) and (2) from ramp (3). See REMOVAL Steps 2 - 4. 2. Remove or install washers (4) and (5) on shaft of handle (2) from inside and outside ramp (3) to obtain proper fit. NOTE Install washers (4) on inside and washers (5) on outside of ramp up to a maximum of nine at each position. 3. Install handles (1) and (2) on ramp. See INSTALLATION Steps 1 - 4. 4. Repeat steps as needed to obtain proper adjustment. FOLLOW-THROUGH STEPS 1. Open and close ramp door to check that ramp door handles are installed properly. 2. Perform chalk test (WP 0556 00). END OF TASK 0569 00-3/4 blank