TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 564 of 936
TM 9-2350-261-20-3 REPLACE WIRE ROPE AND PULLEYS (ALL EXCEPT M1064) — Continued 0564 00 INSTALLATION 1. Route wire rope (6) through pulley mount. 2. Align two pulleys (9) with pulley mount. Secure with two headed pins (8) and new cotter pins (7). 3. Align wire rope end fitting with ramp mount bracket. Secure with headed pin (5) and new cotter pin (4). 4. Align guard (3) and two washers (2) with upper pulley mount. Secure with new spring pin (1). FOLLOW-THROUGH STEPS 1. Connect wire rope to ramp cylinder (WP 0593 00). 2. Install rear floor plate (WP 0436 00). 3. Raise ramp (see your -10). Check that wire rope and pulleys work right. 4. Stop engine (see your -10). END OF TASK 0564 00-2