TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 551 of 936
TM 9-2350-261-20-3 REPLACE RAMP LOCK LEVER AND CABLE (M577A2 AND M1068 ONLY) 0562 00 THIS WORK PACKAGE COVERS: Removal (page 0562 00-1). Clean, Inspect, and Repair (page 0562 00-2). Installation (page 0562 00-3). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0780 00, Item 29) M a t e r i a l s / P a r t s Cotter pin (2) Key washer (4) Locknut (4) Locknut (2) Lockwasher Spring pin (2) P e r s o n n e l R e q u i r e d Unit Mechanic R e f e r e n c e s WP 0561 00 E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) REMOVAL 1. Remove two cotter pins (1), headed pins (2), and clevises (3) from arms (4) and (5). Discard cotter pins. 2. Remove two locknuts (6), washers (7), and screws (8) from lever (9). Discard locknuts. 3. Bend back tabs on key washers. Remove four screws (10), key washers (11), and lever assembly (9) from hull top plate. Discard key washers. 4. Remove front support (12), lever (9), key (13), and rear support (12) from arm (4). Remove arm from bulkhead. 5. Remove two spring pins (14), catch (15), and spring (16) from lever (9). Discard spring pins. 6. Loosen two locknuts (17). Remove two clevises (3) and locknuts (17) from two joints (18). Discard locknuts. 0562 00-1