Sign up to sell your inventory with NSN Lookup

TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download

Page 539 of 936

TM 9-2350-261-20-3 REPLACE RAMP LINKAGE (M1064 ONLY) — Continued 0560 00 CLEAN, INSPECT, AND REPAIR 1. Check rods. Replace any rod that is bent, damaged or has stripped threads. 2. Check bumpers. Replace bumpers that are cracked, torn, or not flexible. 3. Check support blocks. Replace blocks that are worn or binding. 4. Check cross-shaft arm. Remove grooves and scratches with fine sandpaper. Replace worn or pitted arm. 5. Check catch and latch. Replace damaged catch or latch. INSTALLATION 1. Place catch (26) on ramp. Secure with new square washer (25) and screw (24). Bend corner on washer to secure screw. 2. Place washers (23) and trip plate (22) on hull top plate. Make sure you install the same number of washers (23) in the same positions from which they were removed. Secure with two washers (21) , new lockwashers (20), and screws (19). Do not tighten screws at this time. 0560 00-3