TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 526 of 936
TM 9-2350-261-20-3 REPLACE RAMP LINKAGE (M113A2, M901A1, AND M1059 ONLY) — Continued 0558 00 INSTALLATION 1. Place catch (17) on ramp. Secure with new square washer (16) and screw (15). TIGHTEN SCREW TO 60-70 LB-FT (81-95 N·M) TORQUE. Use torque wrench. Bend corner of square washer to lock screw. 2. For hex shaped rod (9), install nut (13), new key washer (12), and clevis (14) on right-hand threaded end of rod (9). Do not bend tabs on key washer until lock adjustment (Step 9). 3. Install flat shaped rod (8) or hex shaped rod (9) in welded brackets. As rod passes through each bracket, install three bumpers (10) on flat shaped rod (8), or three bushings (11) on hex shaped rod (9). 4. Place bracket (7) on hull top plate. Install two washers (6) and screws (5). Do not tighten screws until lock adjustment (Step 9). 5. Align flat shaped rod (8) or hex shaped rod (9) and latch (4) in bracket (7). Secure with four washers (2), headed pin (3), and new cotter pin (1). 0558 00-4