Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download

Page 518 of 936

TM 9-2350-261-20-3 ADJUST RAMP LOCK (M113A2, M901A1, AND M1059 ONLY) — Continued 0556 00 10. For carriers with flat shaped rod (4), place link (10) in clevis (5). Secure with headed pin (11) and new cotter pin (12). 11. Push handle (13) in full forward position. Push bracket (3) to the rear until forward edge of slot in bracket makes contact with cam surface on latch (1). 12. Tighten two screws (2). 13. The latch (1) should point down as shown in illustration. Put your hand under latch and try to lift latch. If adjustment is right, latch will not move. 14. Move handle (13) to full released position. Latch (1) will contact rear edge of bolt in bracket (3) and will move up as shown in illustration. 16. If ramp fails test, check and repeat ADJUSTMENT Steps 1 - 14, as needed. END OF TASK 0556 00-6 15. Wipe chalk off ramp surface and repeat SEAL TEST Steps 1 - 6.