TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 40 of 936
TM 9-2350-261-20-3 REPLACE TRIM VANE RELEASE — Continued 0424 00 6. Lower trim vane (see your -10) and secure in safe position for access to trim vane release handle (11). 7. Lift and secure spring-loaded trim vane release handle (11) for access to internal parts. 8. Remove cotter pin (14), straight pin (12), and clevis rod end (13) from trim vane release (2). Retain cotter pin until adjustments are complete. 9. Loosen nut (15) and turn clevis rod end (13) to change length of clevis rod. Tighten nut. 10. Install clevis rod end (13), straight pin (12), and retained cotter pin (14) on trim vane release linkage (2). 11. Check that trim vane release linkage (2) provides overcenter lock in retracted position. Repeat adjustment procedure for clevis rod ends on extension linkage and trim vane release, if necessary. 12. Remove and discard retained cotter pin (6) from pin (8) on extension linkage clevis rod end (7). Install new cotter pin (6). 13. Remove and discard retained cotter pin (14) from straight pin (12) on trim vane release linkage (2). Install new cotter pin (14). FOLLOW-THROUGH STEPS 1. Raise trim vane (see your -10). END OF TASK 0424 00-4