TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 206 of 936
TM 9-2350-261-20-3 REPLACE MORTAR HATCH EXTERIOR CATCHES AND BUMPERS (M1064 ONLY) — Continued 0467 00 INSTALLATION NOTE Shim(s) are installed between bumper and hull bracket to remove all end play between cover and bumper. 1. Install shim(s) (8) and bumper (7) on hull bracket. Secure with two washers (6) and new locknuts (5). 2. Place catch (3) on door section (4). Secure with four new lockwashers (2) and screws (1). Do not torque screws at this time. NOTE Latch bolt bracket for center door section is mounted on right door section. Bracket for right door section does not have spacers installed. 3. Place latch bolt bracket (9) and two spacers (10) on hull top plate. Secure with four new lockwashers (11) and screws (12). Do not tighten screws at this time. 4. Install spring (13) and tee head bolt (14) on latch bolt bracket (9). Secure with two nuts (15). 5. Install arm (16) through hole in hull top plate. Install washer (17), spring (18), and handle (19) on arm. Secure with new spring pin (20). 6. Install two clevises (21) on chain (22). Secure clevises to arm (16) and tee head bolt (14) with two headed pins (23) and new cotter pins (24). 0467 00-4