TM-9-2350-261-20-3 Unit Maintenance Manual Volume 3 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 145 of 936
TM 9-2350-261-20-3 REPAIR DRIVER’S HATCH (M901A1 ONLY) — Continued 0449 00 16. Check that yoke support assembly linkage (1) is over center. If linkage is not over center, add shim laminations (2) under bracket (3). 17. Push hatch release handle (4) up. Then measure between handle (4) and washer (5). Make sure gap is 0.06 (+0.03, -0.00) inch. If clearance is not within limits, loosen or tighten nut (6), as required. FOLLOW-THROUGH STEPS 1. Start engine (see your -10). 2. Raise and lock ramp (see your -10). 3. Stop engine (see your -10). END OF TASK 0449 00-19/20 blank