TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 889 of 1012
TM 9-2350-261-20-2 BLEED PIVOT STEER SYSTEM 0409 00 THIS WORK PACKAGE COVERS: Servicing (page 0409 00-1). Test and Inspection (page 0409 00-2). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0780 00, Item 29) M a t e r i a l s / P a r t s FRH hydraulic fluid (WP 0782 00, Item 27) P e r s o n n e l R e q u i r e d Unit Mechanic Helper (H) R e f e r e n c e s See your -10 E q u i p m e n t C o n d i t i o n Engine stopped/shutdown (see your -10) Ramp lowered (see your -10) Carrier blocked (see your -10) Trim vane lowered and power plant front access door open (see your -10) SERVICING NOTE Bleed one side of system (two caliper halves) at a time. Keep master cylinder full during bleeding. 1. Attach a short hose and container to bleeder valves (1) (one valve at a time). 2. Remove master cylinder cap (2). Fill cylinder with FRH hydraulic fluid (see your -10). 3. Open bleeder valves (1). 4. Move handle (3) until fluid coming out of bleeder valves (1) is free of air. 5. Hold handle (3) back in applied position (as shown) and close bleeder valves (1). 0409 00-1