TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 876 of 1012
TM 9-2350-261-20-2 REPLACE NEUTRAL START SWITCH — Continued 0406 00 CLEAN, INSPECT, AND REPLACE 1. Clean switch with a clean, dry cloth. 2. Check neutral start switch (WP 0009 00). 3. Check switch. Replace switch that has worn or damaged arm or roller. 4. Check switch leads. Replace damaged leads (WP 0312 00) or switch. INSTALLATION 1. Install neutral start switch (8) on housing (3). Secure with two screws (4), washers (5), new lockwashers (6), and nuts (7). Do not tighten nuts. 2. Place selector (9) in neutral. 3. Slide neutral start switch (8) and attaching screws (4) up or down in elongated holes in housing (3) to set switch adjustment. Moving switch (8) down moves lever (10) closer to actuating cam (11). This increases selector (9) travel with switch actuated. 4. Adjust neutral start switch (8) so that electrical continuity is maintained as follows, use digital multimeter: a. Neutral start switch (8) must maintain electrical continuity between circuits 74 and 74A at the N position. NOTE Switch must break electrical continuity between circuits 74 and 74A before reaching R or 2–3 position when shifting from N position. 5. When adjustment is correct, tighten two nuts (7). 6. Secure cover (2) to housing (3) with two screws (1). 0406 00-2