TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 859 of 1012
TM 9-2350-261-20-2 REPLACE HAND THROTTLE — Continued 0402 00 INSTALLATION 1. Install new grommet (1) in driver’s floor plate. 2. Feed cable assembly (2) through mounting hole in driver’s compartment bulkhead to power plant front access door opening. 3. Slide washer (3) and nut (4) on cable assembly (2). Secure to driver’s compartment bulkhead. 4. Install cable assembly (2) on two weldnuts (5). Secure with two washers (6), screws (7), and four clamps (8). 5. Install cable assembly (2) on weldnut (9). Secure with two straps (10), screws (11), new lockwasher (12), and new locknut (13). 6. Install pin (14) on accelerator pedal assembly (15). Secure with washer (16) and new cotter pin (17). 7. Install cable assembly (2) on pin (14). Secure with collar (18) and set screw (19). ADJUSTMENT 1. Loosen set screw (19). Push control cable assembly (2) handle full forward. 2. Place pedal assembly (15) in full closed throttle position (see your -10). Tighten set screw (19) in collar (18). FOLLOW-THROUGH STEPS 1. Start engine (see your -10). Using the pedal, check that hand throttle operates properly. 2. Stop/shutdown engine (see your -10) 3. Close power plant front access door (see your -10). 4. Raise trim vane (see your -10). 5. Install driver’s power plant access panel (see your -10). END OF TASK 0402 00-3/4 blank