TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 820 of 1012
TM 9-2350-261-20-2 REPLACE DIFFERENTIAL CROSS-SHAFTS AND BEARINGS — Continued 0392 00 INSTALLATION 1. Install bearing (9) in bearing (1). Secure with two retaining rings (8). 2. Install lubrication fitting (10) in bearing (1). 3. Assemble cross-shaft (2), cross-shaft (5), two bearings (6), two thrust washers (7), bearing (1), woodruff key (11), and link arm (12). 4. Install screw (13) and new locknut (14) in link arm (12). Do not tighten nut. 5. Place cross-shaft (2), cross-shaft (5), two bearings (6), and bearing (1) as a unit on two brackets (15). 6. Install two bearings (6) on two brackets (15). Secure with four screws (16), washers (17), and new locknuts (18). 7. Install bearing (1) and shim (19) to driver’s compartment bulkhead. Secure with two screws (20), four washers (21), and two new locknuts (22). 8. Install four links (23) to cross-shaft (2), cross-shaft (5), and link arm (12). Secure with four clevis pins (24) and new cotter pins (25). 9. Tighten four set screws (3) in two bearing collars (4). 10. Tighten nut (14) on link arm (12). 0392 00-4