TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 788 of 1012
TM 9-2350-261-20-2 REPLACE TORSION BAR ANCHOR — Continued 0386 00 REMOVAL 1. Remove two cotter pins (1) and pins (2) from torsion bar anchor (3). Discard cotter pins. 2. Remove two screws (4) from anchor (3) on fifth torsion bar anchors (M1064 only). 3. Remove anchor (3) and preformed packing (5) from hull mount. Discard preformed packing. CLEAN, INSPECT, AND REPLACE 1. Check torsion bar anchor and pins for wear and damage. Replace if needed. INSTALLATION NOTE Preformed packing (1) is installed on third, fourth, and fifth anchor on all carriers. 1. Place new preformed packing (1) and torsion bar anchor (2) on hull mount. 2. Install two screws (3) in anchor (2) on fifth torsion bar anchor (M1064 only). TIGHTEN SCREWS TO 320-330 LB-FT (434-447 N·M) TORQUE. Use torque wrench. 0386 00-2