TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 785 of 1012
TM 9-2350-261-20-2 REPLACE TORSION BAR — Continued 0385 00 6. Install screw (5) in plug (4). NOTE You may need to jack carrier, to raise road arm, before positioning road wheel lifter. 7. Position road wheel lifter (WP 0371 00) (T130) or (WP 0372 00) (T150). FOLLOW-THROUGH STEPS 1. Install floor plates for third and fourth torsion bars (WP 0436 00). 2. Install driver’s rear floor plate for second torsion bar, left side only (WP 0439 00). 3. Install power plant rear access panel for second torsion bar, right side only (see your -10). 4. Install driver’s front floor plate for first torsion bar, left side only (WP 0439 00). 5. Install power plant for first torsion bar, right side only (WP 0131 00). 6. If removed, install shock absorber (WP 0379 00). 7. Install road wheel (WP 0371 00) (T130) or (WP 0372 00) (T150). 8 . Road test carrier to check that torsion bar is installed properly (WP 0120 00). 9. Stop/shutdown engine (see your -10). END OF TASK 0385 00-5/6 blank