TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 763 of 1012
REPLACE SHOCK ABSORBER — Continued INSTALLATION 1. Install new inner seal (1) on support arm pin (2). NOTE Exercise new shock absorber to the fully extended position and move shock absorber back and forth several times until resistance can be felt throughout the entire length of the stroke. Make sure shock absorber is installed with large end of bearings installed first. 2. Install shock absorber (3), new outer seal (4), and shoulder washer (5) on support arm pin (2). 3. Install new inner seal (1), shock absorber (3), new outer seal (4), and shoulder washer (5) on hull bracket (6). 4. Secure shock absorber (3) with two nuts (9). 5. TIGH TEN T W O NUTS (9) TO 60-80 L B-FT (81-109 N ·M) TORQU E. Use torqu e w rench . Secure w ith n ew cot pins (10). FOLLOW-THROUGH STEPS 1. Inst all r oad wheel (WP 0371 00). 2. Road test carrier to check that shock absorber i s installed properly (WP 0120 00). END OF TASK 0379 00-3/4 blank 0379 00 TM 9-2350-261-20-2