TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 742 of 1012
TM 9-2350-261-20-2 REPLACE ROAD WHEEL SUPPORT ARM, BEARINGS, AND SEALS — Continued 0374 00 WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 5. Put light coat of sealing compound on outer surface of new seal (3). 6. Install new gasket (5), retainer (4), and seal (3) in rear of housing (6). Use replacer. Secure with three new washers (2) and six screws (1). Do not tighten screws at this time. 7. Fill support arm housing (6) with grease until grease appears around retainer (4). 8. TIGHTEN SIX SCREWS (1) TO 168–228 LB-IN (19-26 N·M) TORQUE. Use torque wrench (WP 0780 00, Item 102). Bend tabs on new washers (2). 0374 00-4