TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 737 of 1012
TM 9-2350-261-20-2 REPLACE ROAD WHEEL HUB — Continued 0373 00 7. Place hub (1) on road wheel support arm (2). Completely pack cavity in hub with grease. 8. Pack outer bearing (3) with grease. Install in hub (1). 9. Install washer (4) and nut (5) on support arm (2). Tighten nut to adjust bearing as follows: a. TIGHTEN NUT (5) TO 140-150 LB-FT (190-203 N·M) TORQUE. Use torque wrench. b. Back off nut (5) until there is no torque. c. TIGHTEN NUT (5) TO 70-75 LB-FT (95-102 N·M) TORQUE. Use torque wrench. d. Back off nut to align nearest cotter pin hole in nut with cotter pin hole in support arm (2). 10. Install new cotter pin (6) in support arm (2). 11. Install new gasket (7), hub cap (8), and four screws (9) in hub (1). 12. Fill hub (1) with grease (WP 0120 00). FOLLOW-THROUGH STEPS 1. Install road wheel (WP 0371 00) (T130) or (WP 0372 00) (T150). 2. Road test carrier to check that hub is installed properly (WP 0120 00). 3. Check track tension (see your -10). END OF TASK 0373 00-5/6 blank