TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 641 of 1012
TM 9-2350-261-20-2 REPLACE RIGHT FINAL DRIVE SHAFT 0349 00 THIS WORK PACKAGE COVERS: Removal (page 0349 00-1). Installation (page 0349 00-2). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0780 00, Item 29) Torque Wrench Adapter (WP 0780 00, Item 8) Torque Wrench (WP 0780 00, Item 103) Vise (WP 0780 00, Item 83) M a t e r i a l s / P a r t s Locknut (4) Screw (16) P e r s o n n e l R e q u i r e d Unit Mechanic E q u i p m e n t C o n d i t i o n Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) Trim vane lowered (see your -10) Power plant front access door open (see your -10) REMOVAL NOTE Place gear range selector in neutral position. Set or release differential steering brakes as required to rotate or lock drive shaft during removal and installation. 1. Remove eight screws (1) and washers (2) from universal joints (3). Pry universal joints loose and slide yoke (4) into final drive (5). Discard screws. 2. Remove propeller shaft (6) with universal joints (3) from carrier. 3. Position propeller shaft (6) in vise. Remove eight screws (7) and washers (8) from universal joints and shaft. Discard screws. 4. Remove yoke (4) from final drive (5). 5. Remove four locknuts (9) and adapter (10) from differential (11). Discard locknuts. 0349 00-1