TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 538 of 1012
TM 9-2350-261-20-2 REPLACE ENGINE LOW OIL PRESSURE SWITCH — Continued 0316 00 INSTALLATION WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 1. If removed, coat threads of bushing (3) with sealing compound. 2. Install bushing (3) in engine block (4). 3. Install switch (2) in bushing (3). 4. Connect circuit 34 lead (1) to switch (2). FOLLOW-THROUGH STEPS 1. Connect battery ground lead (WP 0294 00). 2. Turn MASTER SWITCH to ON and observe low oil pressure warning light. Light should go on (see your -10). 3. Start engine and check for oil leaks at engine low oil pressure switch. Low oil pressure warning light should go out after engine is started. Stop engine (see your -10). 4. Turn MASTER SWITCH to OFF (see your -10). 5. Close power plant front access door, and raise trim vane (see your -10). END OF TASK 0316 00-2