TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 531 of 1012
TM 9-2350-261-20-2 REPAIR CABLE ASSEMBLY 0314 00 THIS WORK PACKAGE COVERS: Disassembly ( page 03 14 00 -1 ). Clean, Inspect, and Repair (page 0314 00-2). Assembly ( pag e 0 314 0 0-2 ). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s Digital Multimeter (WP 0780 00, Item 43) Electrical Tool Kit (WP 0780 00, Item 80) General Mechanic’s Tool Kit (WP 0780 00, Item 29) Soldering Gun (WP 0780 00, Item 33) M a t e r i a l s / P a r t s Insulation sleeving (WP 0782 00, Item 30) Insulation sleeving (WP 0782 00, Item 31) Insulation sleeving (WP 0782 00, Item 32) Insulation sleeving (WP 0782 00, Item 33) Insulation sleeving (WP 0782 00, Item 34) Solder (WP 0782 00, Item 71) P e r s o n n e l R e q u i r e d Unit Mechanic E q u i p m e n t C o n d i t i o n Engine stopped/shutdown (see your -10) Battery ground lead disconnected (WP 0294 00) Carrier blocked (see your -10) DISASSEMBLY NOTE Use same procedure for repairing single or multiple lead, and male or female receptacle. 1. Loosen retaining nut (1) from plug (2). Slide nut back on cable (3). 2. Remove grommet (4) with contacts (5) from rear of plug (2). 3. Remove plug (2) and coupling nut (6) from cable (3). 4. Push leads of cable (3) into grommet (4) until contacts (5) are fully exposed on other side of grommet. Clip or desolder leads from contacts. Use soldering gun. Discard contacts. 5. Remove grommet (4) and retaining nut (1) from cable (3). 0314 00-1