TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 472 of 1012
TM 9-2350-261-20-2 REPLACE BATTERY LEADS (M1064 ONLY) — Continued 0300 00 INSTALLATION 1. Place terminal lugs (4) on battery (7). Secure with screw (6) and nut (5). 2. Place jumper lead (2) on two screws (3) of terminal lugs (4). Secure with two nuts (1). NOTE Install circuit 6 and 48 positive leads before installing circuit 7 ground lead. Instructions for installation are the same. 3. Install circuit 7 lead (8) as follows: a. Place lead (8) on hull mount. Secure with screw (9), two washers (10), and nut (11). b. Install new grommet (12) in battery compartment. Route lead (8) through grommet into battery compartment. c. Place lead (8) on screw (3) on terminal lug (4) and secure with nut (1). 4. Coat tops of four battery terminal lugs with grease. C A U T I O N Battery cells can be damaged if the batteries are hooked up incorrectly. Make sure batteries are hooked up correctly. 5. Push in drawer (13) and turn handle to secure. FOLLOW-THROUGH STEPS 1. Turn MASTER SWITCH to ON. Check BATT- GEN gauge on instrument panel. Gauge should read in green or yellow zone (see your -10). 2. Start engine (see your -10). 3. Raise and lock ramp (see your -10). 4. Stop/shutdown engine (see your -10). END OF TASK 0300 00-4