TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 39 of 1012
TM 9-2350-261-20-2 REPLACE THERMOSTAT, HOUSING, AND DEAERATION ELBOW — Continued 0200 00 8. Loosen two clamps (1). Slide hose (2) off the housing (3). 9. Remove two screws (4), lockwashers (5), and washers (6) securing housing (3) to the engine. Remove housing (3) and gasket (7). Discard lockwashers and gasket. 10. If hose (2) is damaged, slide off tube (8). Discard hose. INSTALLATION 1. If hose (2) was discarded, slide new hose on tube (8). Slide two clamps (1) on hose. Do not tighten. WARNING Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you dizzy and irritate your eyes and throat. Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes. Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves. 2. Apply sealing compound (WP 0782 00, Item 62) to both sides of new gasket (7). Place gasket on housing (3). Secure housing (3) on engine with two screws (4), new lockwashers (5), and two washers (6). 3. Slide hose (2) onto housing (3). Position two clamps (1) on each end of hose, and tighten. 0200 00-3