TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 186 of 1012
TM 9-2350-261-20-2 REPLACE GENERATOR DRIVE BELTS (200 AMP GENERATOR ONLY) — Continued 0234 00 INSTALLATION 1. Install new drive belt (1) on drive pulley (2) and generator pulley (3). 2. Turn turnbuckle (4) and tighten belt until belt deflection at midspan is 1/2 to 5/8 inch (13 to 16 mm) when force is applied. 3. Tighten locknut (5) on rod end (6). 4. Tighten two screws (7) on generator mounting bracket. FOLLOW-THROUGH STEPS WARNING Wearing loose clothing around moving parts can allow personnel to get caught and could result in injury or death. Tuck in loose clothing. 1. Start engine (see your -10). Check that generator drive belts are installed properly. 2. Stop/shutdown engine (see your -10). 3. Install power plant rear access panels (WP 0431 00, WP 0432 00, and WP 0433 00). END OF TASK 0234 00-2