TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 154 of 1012
TM 9-2350-261-20-2 REPLACE GENERATOR DRIVE BELTS (100 AMP GEN ONLY) — Continued 0226 00 REPAIR OR REPLACEMENT 1. Inspect drive belts. If either belt is worn or damaged, discard both old belts and install new ones. INSTALLATION NOTE When replacing drive belts, replace in matched sets only. 1. Install two new drive belts (1) on drive pulley (2) and generator pulley (3). 2. Turn turnbuckle (4) and tighten belt until belt deflection at midspan is 1/2 to 5/8 inch (13 to 16 mm) when 25 lbs (11 kg) of force is applied. 3. Tighten locknut (5) on rod end (6). FOLLOW-THROUGH STEPS WARNING Wearing loose clothing around moving parts can allow personnel to get caught and could result in injury or death. Tuck in loose clothing. 1. Start engine (see your -10). 2. Stop/shutdown engine (see your -10). 3. Install power plant rear access panels (WP 0431 00, WP 0432 00, and WP 0433 00). END OF TASK 0226 00-2