TM-9-2350-261-20-2 Unit Maintenance Manual Volume 2 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 108 of 1012
TM 9-2350-261-20-2 REPLACE AUXILIARY POWER (SLAVE) RECEPTACLE (ALL EXCEPT M577A2 AND M1068) — Continued 0218 00 INSTALLATION NOTE Steps 1 - 8 tell you how to install the late model slave receptacles. Steps 9 - 14 tell you how to install the early model slave receptacles. NOTE Make sure protective cap retaining cord is attached to receptacle lower mount screw. 1. Install insulator (1), new gasket (2), and auxiliary power receptacle (3) in master switch panel (4). Secure with four screws (5), washers (6), and new locknuts (7). 2. Install new grommet (8) on ground lead (9). Route lead out of master switch panel (4). Install grommet in panel. 3. Place ground lead (9) on instrument panel strut hull mount. Secure with screw (10), washer (12), and nut (11). 4. Install circuit 50 lead (13) and circuit 49 lead (14) on terminal of master switch (15). Secure with washer (16) and nut (17). 5. Install ground lead (9) on negative post (18) of auxiliary power receptacle (3). Secure with screw (19) and new lockwasher (20). 6. Install circuit 50 lead (13) on positive post (21) of auxiliary power receptacle (3). Secure with screw (22) and new lockwasher (23). 7. Install master switch panel (4) on distribution box. Secure with eight screws (24), washers (25), and new locknuts (26). 8. Connect circuit 37 lead (27) to connector (28). 0218 00-4