TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 983 of 1236
TM 9-2350-261-20-1 REPLACE FUEL QUANTITY TRANSMITTER (M577A2 AND M1068 ONLY) 0155 00 THIS WORK PACKAGE COVERS: Removal (page 0155 00-1). Cleaning (page 0155 00-2). Installation (page 0155 00-2). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0780 00, Item 29) M a t e r i a l s / P a r t s Cleaning compound, solvent (WP 0782 00, Item 16) Non-electrical wire (WP 0782 00, Item 40) Gasket P e r s o n n e l R e q u i r e d Unit Mechanic R e f e r e n c e s See your -10 WP 0153 00 E q u i p m e n t C o n d i t i o n Engine stopped/shutdown (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Battery ground lead disconnected (WP 0294 00) Map board removed (see your -10) Work tables removed (WP 0500 00, WP 0501 00, or WP 0502 00) REMOVAL NOTE Right and left fuel quantity transmitter are removed and installed in the same way. The following steps apply to only one transmitter. 1. Drain fuel tank to less than 3/4 full (WP 0153 00). 2. Disconnect lead (1) from transmitter (2). Circuit 29 lead is for right transmitter. Circuit 30 lead is for left transmitter. 3. Remove lockwire (3) from five screws (4). Discard lockwire. 4. Remove five screws (4), ground lead (5), transmitter (2), and gasket (6) from fuel tank. Discard gasket. 0155 00-1