TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 851 of 1236
TM 9-2350-261-20-1 REMOVE/INSTALL POWER PLANT — Continued 0131 00 20. Install clamp (3) on radiator inlet tube (4). Secure clamp to hanger (5) with washer (6), screw (7), and nut (8). NOTE Screws and washers must be clean, dry, and free of lubricants and paint. If your carrier is equipped with 6C universal joints, screws are 3/8-24 x 1-3/4; if equipped with 7C universal joints, screws are 1/2-20 x 2. 21. Connect propeller shaft (9) to transmission with four new washers (10) and new screws (11). TIGHTEN 6C UNIVERSAL JOINTS TO 35-40 LB-FT (47-54 N·M) TORQUE. Use torque wrench (WP 0780 00, Item 103) and adapter (WP 0780 00, Item 7). TIGHTEN 7C UNIVERSAL JOINTS TO 83-100 LB-FT (113-136 N·M) TORQUE. Use torque wrench (WP 0780 00, Item 103) and adapter (WP 0780 00, Item 6). Loosen screws and retighten to correct torque again. See WP 0120 00 for correct readings on torque wrenches with adapters. 22. Install left and right final drive propeller shafts (WP 0348 00 and WP 0349 00). 0131 00-17