TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 805 of 1236
TM 9-2350-261-20-1 REPLACE CRANKCASE BREATHER COLLECTOR CAN AND HOSE — Continued 0127 00 INSTALLATION 1. Install collector can bracket (1) on transmission case. Secure with two screws (2) and new tab washers (3). TIGHTEN SCREWS (2) TO 252-300 LB-IN (28-34 N·M) TORQUE. LOOSEN SCREWS AND RETIGHTEN TO ABOVE TORQUE. Use torque wrench and socket set. 2. Install clean element (4) in collector can (5). 3. Install collector can (5) on bracket (1). Secure with retainer (6), two washers (7), and wing nuts (8). Stake top threads of retainer studs after installing wing nuts. 4. Install two drain hoses (9) and (10) in collector can bracket (1). 5. Install breather hose (11) in collector can bracket (1). Secure with screw (12), clamp (13), and nut (14). 6. Install breather hose (11) on engine and on power plant disconnect bracket. Secure with two clamps (15), clamp (16), washer (17), nut (18), and two screws (19). FOLLOW-THROUGH STEPS 1. Install power plant rear access panel (WP 0431 00, WP 0432 00, or WP 0433 00). 2. Install driver’s power plant access panel (WP 0430 00). END OF TASK 0127 00-3/4 blank