TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 611 of 1236
TM 9-2350-261-20-1 STE/ICE-R TEST 14 COMPRESSION UNBALANCE (POWER CABLE) 0113 00 THIS WORK PACKAGE COVERS: Test (page 0113 00-1). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s STE/ICE-R Test Set (WP 0780 00, Item 73) P e r s o n n e l R e q u i r e d Unit Mechanic E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) STE/ICE-R power hooked up (WP 0106 00) Warm engine to operating temperature (see your -10) Disengage transfer gearcase (see your -10) Run test 72 (WP 0115 00) Run test 73 (WP 0116 00) Run test 74 (WP 0117 00) Run test 75 (WP 0116 00) TEST NOTE If VID has been performed during power hook up procedure (WP 0106 00), go to Step 2. If not, then continue with Step 1. 1. Enter VID. a. Set TEST SELECT switches to 60. b. Press and release TEST button. c. Wait for prompting message UEH to appear on display. d. Set TEST SELECT switches to 03 for vehicle being tested. e. Press and release TEST button. f. Wait for VTM to display and hold VID number. NOTE Do not run more than two compression unbalance tests in a row. Idle engine between pairs of compression unbalance tests. Crank engine without fuel for 5 seconds to clear fuel from cylinders. 2. Perform test. a. Set TEST SELECT switches to 14. b. Press and release TEST button. c. Wait for prompting message UEH to appear on display. If UEH does not appear on display, go to Step g. d. Set TEST SELECT switches to 03. e. Press and release TEST button. NOTE The number just entered will remain on the display only a few seconds. f. Wait for VTM to display the VID just entered. g. Wait for prompting message CYL to appear on display. If cylinder does not appear, go to Step y. 0113 00-1