TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 610 of 1236
TM 9-2350-261-20-1 STE/ICE-R TEST 13 POWER (PERCENT) — Continued 0112 00 d. Set TEST SELECT switches to 03. e. Press and release TEST button. NOTE The number just entered will remain on the display only a few seconds. f. f. Wait for VTM to display the VID just entered. NOTE If a prompting message Po-1 appears on the display, refer to Step 2c for Po-1 and Step 2d for Po-2. If prompting message Po-1 does not appear on the display, go to Step 1. g. Wait for prompting message Po-1 to appear on display. h. Set TEST SELECT switches to Po-1 value. i. Press and release TEST button. j. Wait for prompting message Po-2 to appear on display. k. Set TEST SELECT switches to Po-2 value. l. Press and release TEST button. m. When CIP is displayed, sharply depress accelerator. Hold it to the floor. When VTM displays OFF, release accelerator. C A U T I O N To prevent damage to equipment, allow engine to idle for at least two minutes after running power test. n. A number will be displayed after engine has returned to idle speed. This number is the test result in units of percent of nominal rated power. 4. Return to troubleshooting. Table 1. % Power: Minimum Test Limit Vehicle Altitude 0 to 2000 ft 2000 ft to 4000 ft Above 4000 ft M113 FOV 75% 66% 60% 0112 00-2