TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 609 of 1236
TM 9-2350-261-20-1 STE/ICE-R TEST 13 POWER (PERCENT) 0112 00 THIS WORK PACKAGE COVERS: Test (page 0112 00-1). INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s STE/ICE-R Test Set (WP 0780 00, Item 73) P e r s o n n e l R e q u i r e d Unit Mechanic E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) STE/ICE-R power hooked up (WP 0106 00) STE/ICE-R engine RPM test hooked up (WP 0107 00) Warm engine to operating temperature (see your -10) TEST NOTE If VID has been performed during power hookup procedures (WP 0106 00), go to Step 2. If not, continue with Step 1. 1. Enter VID. a. Set TEST SELECT switches to 60. b. Press and release TEST button. c. Wait for prompting message UEH to appear on display. d. Set TEST SELECT switches to 03. e. Press and release TEST button. f. Wait for VTM to display and hold VID number. NOTE Engine idle speed must be checked before performing power test. If idle speed is not within limits specified for vehicle/equipment, adjust idle speed to be within proper limits. Do not run power test if idle speed cannot be properly adjusted. 2. Start and idle engine. a. Set TEST SELECT switches to 10. b. Press and release TEST button. c. Observe displayed value (RPM) and adjust idle speed if necessary. d. Observe displayed value (RPM). C A U T I O N Engine governor speed must be checked before performing power test. If governor speed is not within limits specified for vehicle/equipment, notify direct support maintenance. Do not run power test if governor speed is not within specified limits. Damage to engine may result. 3. Perform power test. a. Set TEST SELECT switches to 13. b. Press and release TEST button. c. Wait for prompting message UEH to appear on display. If UEH does not appear on display, go to Step g. 0112 00-1