TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 592 of 1236
TM 9-2350-261-20-1 STE/ICE-R ENGINE WILL CRANK BUT WILL NOT START TROUBLESHOOTING — Continued 0105 00 Y C A U T I O N Operation of engine with red stripe transducer installed could damage transducer. Remove red stripe transducer before starting engine. 1. Verify that there is fuel in fuel tank. 2. Bleed air out of fuel system as necessary. 3. Drain water from primary fuel filter. 4. Check for kinked, flattened, or broken fuel lines. 5. Check quick disconnect fittings for blockage in fittings. 6. Check fuel shutoff cable (WP 0403 00). 7. Check engine fuel pump (WP 0171 00). 8. Disconnect fuel supply hose (1) from secondary fuel filter (2). 9. Connect red stripe pressure transducer (3) to secondary fuel filter outlet. 10. Connect transducer cable W4 P1 (4) to J3 on VTM (5). 11. Connect transducer cable W4 P2 (6) to red stripe pressure transducer (3). 12. Set test select switches to 49. 13. Press and hold test until CAL appears on display. 14. Is offset value within range of −4 to + 4? YN 1. Go to Offset Fault Isolation. See TM 9-4910-571-12&P. 2. Verify no faults found. 2Y 1. Turn on fuel and accessory switches. 2. Press and release test button. 3. Crank engine and read display. 4. Is fuel pressure greater than 4 psi (28 kPa)? 2YN GO TO BY (PAGE 0105 00-3) 0105 00-2