TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 583 of 1236
TM 9-2350-261-20-1 STE/ICE-R LOW OIL PRESSURE TROUBLESHOOTING 0102 00 INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0780 00, Item 29) STE/ICE-R Test Set (WP 0780 00, Item 73) P e r s o n n e l R e q u i r e d Unit Mechanic E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) Trim vane lowered (see your -10) Power plant access door open (see your -10) STE/ICE-R hooked up for power (WP 0106 00) STE/ICE-R engine RPM test hooked up (WP 0107 00) T 1. Remove oil pressure sending unit (1) from engine. 2. Install blue striped pressure transducer (2) in place of oil pressure sending unit (1). 3. Connect transducer cable W4 P1 (3) to J3 (4) on VTM. 4. Connect transducer cable W4 P2 (5) to pressure transducer (2). 5. Set test select switches to 50. 6. Press and hold test button until CAL appears on display. 7. Is offset value within −150 to + 150? TN 1. Go to Offset Fault Isolation. See TM 9-4910-571-12&P. 2. Verify no faults found. 0102 00-1