TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 557 of 1236
TM 9-2350-261-20-1 STE/ICE–R PROCED URE S (SIMPLIFIED TEST EQU IPMEN T F OR INTERNAL COMB USTION EN GINES REP ROGR AMMABLE) — Continued 0099 00 Prompting Messages Prompting messages tell the operator to do something. After the operator action is completed, testing will continue. Some of the prompting messages and their meanings are as follows: DISPLAY MEANING UEH Tells the operator to enter VID on the TEST SELECT switches. CYL Tells the operator to enter the number of cylinders into the VTM. GO Tells the operator to crank engine. 0066 Tells the operator to set TEST SELECT switches to 99 during confidence test. CAL Tells the operator to release the TEST button during an offset test. CIP Tells the operator to apply full throttle in a CI power test. Confidence Test Error Messages Confidence test messages are displayed either as PASS or by a C followed by three numbers (#). A C### is an error message used by VTM repair personnel as an aid in troubleshooting. If a C### message appears during confidence test or during normal operation, go to confidence test fault isolation, TM 9-4910-571-12&P, for the necessary corrective action. TEST METHOD The test method consists of a pre-test inspection and STE/ICE–R testing. Pre-test Inspection Before using STE/ICE–R to test the carriers, perform the following pre-test inspections: a. Fan Belts. Check for proper tension. Replace if cracked or frayed. b. Oil Level. Bring up to proper level if low. c. Fuel Level. Check that the fuel tank has enough fuel for testing. d. Radiator. Bring up to proper level if low. e. Battery. Replace the battery if the case is cracked or the terminal posts are damaged. Clean off all corrosion. Check that the battery connections to ground and starter motor are in good condition, securely connected, and clean. Check the electrolyte level (see TM 9-6140-200-14). If low, bring up to proper level with distilled water. 0099 00-9