TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 555 of 1236
TM 9-2350-261-20-1 STE/ICE–R PROCED URE S (SIMPLIFIED TEST EQU IPMEN T F OR INTERNAL COMB USTION EN GINES REP ROGR AMMABLE) — Continued 0099 00 TRANSIT CASE The STE/ICE–R is housed in a portable protective transit case which contains all necessary accessories and instructions. A pressure relief valve located on the front of the case allows the operator to release any pressure or vacuum resulting from changes in climate during transit. READOUT DISPLAY MESSAGES Error Messages Error messages indicate the VTM needs additional or corrected information before testing can continue or additional procedures are required. All error messages are displayed as an E followed by three numbers (for example, E003). DISPLAY MEANING E000 VTM has been asked for information that it does not have. For example, you have requested the vehicle/equipment ID and it has not been entered. E001 A test number which does not exist has been entered on the TEST SELECT switches. E002 The required transducer is not connected. E003 Test number wrong for DCA connected. This can occur if test selected does not apply to the class of vehicle/equipment under test or if the DCA harness does not have the required transducer. E004 No longer used. If message appears, turn in test set. E005 Required offset test was not performed. E007 The VID number and number-of-cylinders information entered do not agree. E008 VTM is not receiving required voltage signal for selected test. This message can occur on tests 14, 15, and 72 through 79. E009 VTM is not receiving engine speed signal. This applies only to engine power test and SI full power simulation. E010 A wrong VID number was entered. The VTM will only accept numbers between 01 and 99. If E010 is displayed when the VID entered was between 01 and 99, it means that the VID does not agree with the identity of the DCA harness powering the VTM. The VTM will accept this, allowing you to power through the DCA while testing another vehicle. E011 Throttle control was operated incorrectly. It was taking too long to accelerate or decelerate during power test. E012 The SI ignition adapter, TK item 30, or CI pulse tachometer, TK item 34, is missing or is not connected to the VTM. E013 VTM is unable to use data received. E014 The wrong number of cylinders was entered. E015 No longer used. If message appears, turn in test set. E017 VTM is not receiving ignition information during dwell test. E018 Test discontinued due to no information being detected by VTM. This will occur after several minutes of no-signal operation. 0099 00-7