TM-9-2350-261-20-1 Unit Maintenance Manual Volume 1 M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 349 of 1236
TM 9-2350-261-20-1 RAMP WILL NOT RAISE OR FREE FALLS 0064 00 INITIAL SETUP: M a i n t e n a n c e L e v e l Unit T o o l s a n d S p e c i a l T o o l s General Mechanic’s Tool Kit (WP 0780 00, Item 29) P e r s o n n e l R e q u i r e d Unit Mechanic R e f e r e n c e s See your -10 E q u i p m e n t C o n d i t i o n Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Driver’s power plant access panel removed (see your -10) Power plant access door opened (see your -10) Power plant rear access panels removed (see your -10) Rear compartment floor plates removed (WP 0436 00, WP 0437 00, WP 0438 00, WP 0439 00, WP 0440 00, or WP 0441 00) T 1. If ramp will not raise, check engine disconnect lever. Ensure lever is locked in the OUT (engage) position (see your -10). 2. Check ramp hydraulic fluid tank sight glass level (see your -10). 3. Is fluid level correct? TN GO TO BY (PAGE 0064 00-3) Y 1. Inspect ramp wire rope (1) and/or pulleys (2). 2. Are wire rope and pulleys in good condition? YN 1. Replace wire rope and/or pulleys (WP 0564 00 or WP 0565 00). 2. Verify no faults found. 0064 00-1