TM-9-2350-261-10 Operator Manual M113A2 M577A2 M1064 M1068 M1059 M901A1 Download
Page 632 of 764
TM 9-2350-261-10 SERVICE BILGE PUMPS — Continued 0086 00 2. Remove six screws, washers, and rear floor plate from floor supports. Use 1/2 inch drive socket wrench handle and 3/4 inch socket. 3. Service rear bilge pump. Use flashlight. 4. Remove mud and debris from bilge pump and screen. If bilge pump needs additional cleaning, notify unit maintenance. 5. Clean vent hole. Use a wire and run it back and forth in vent hole a few times. 6. Install rear floor plate on floor supports and secure with six washers and screws. Use 1/2 inch drive socket wrench handle and 3/4 inch socket. 7. Raise ramp (WP 0015 00). 0086 00-4