TM-9-2350-247-20-3 Unit Maintenance Manual Volume 3 M548A1 M548A3 Tracked Cargo Carrier Download
Page 45 of 832
TM 9-2350-247-20-3 REPLACE CAB DOOR, HANDLES, AND LINKAGE — Continued 0386 00 ADJUSTMENT 1. Turn MASTER SWITCH OFF (see your -10). 2. Latch and seal adjustment. a. Loosen two screws (1). Slide door catch (2) in or out to 1/4-1/2 inch (6-13 mm) compression of door seal (3). b. Add or remove hinge lug spacer washers (4 or 5) as needed to get 1/4-1/2 inch (6-13 mm) compression of door seal (3) on hinge side of door. c. Make sure latch (6) and catch (2) fully engage. If needed, remove two screws (1) and washers (7) that secure catch to hull. Add or remove shims (8) as needed for full engagement. d. Install catch (2) with two screws (1) and washers (7). NOTE Top edge of door assembly should align with top edge of cowl assembly. 3. Door adjustment (carriers with two hinge lugs). a. Remove two screws (9), washers (10), and hinge lug spacer washer(s) (5) that secure bottom two hinge lugs (11). Remove bottom lugs. b. Add or remove shim washers (12) for proper alignment of door and hull. c. Install lugs (11) on door hinge strap (13). d. Put shim washers (12) in place. Secure with two screws (9), washers (10), and hinge lug washer(s) (5). 4. Door adjustment (carriers with single hinge lug). a. Remove lower hinge cotter pin (14), washer (15), and pin (16). Add shim washer(s) (17) to get proper door and hull alignment. Discard cotter pin. b. Install hinge pin (16), washer (15), and new cotter pin (14). FOLLOW-THROUGH STEPS 1. Install cab door window (WP 0381 00). END OF TASK 0386 00-7/8 blank