TM-9-2350-247-20-3 Unit Maintenance Manual Volume 3 M548A1 M548A3 Tracked Cargo Carrier Download
Page 198 of 832
TM 9-2350-247-20-3 REPLACE WINDSHIELD WIPER MOTOR — Continued 0420 00 INSTALLATION 1. Place pivot post of windshield wiper motor (1) through hole in bracket (2). 2. Install three screws (3) and six new lockwashers (4) to secure windshield wiper motor (1) to bracket (2). Place washers on each side of bracket. Do not tighten screws. 3. Slide clamp (5) over end of windshield wiper motor (1). Secure clamp to bracket with screw (6) and new locknut (7). Tighten all screws. 4. Place end of link (8) on pivot post of windshield wiper motor (1). Install washer (9) and clip (10) on pivot post. 5. Install capacitor (11) on weldnut (12) with screw (13). 6. Pull nipple (14) back and install new lockwasher (15), lead (16), new lockwasher (15), and capacitor lead (17) on screw (18). Install screw in windshield wiper motor (1). FOLLOW-THROUGH STEPS 1. Connect battery negative lead(s) (WP 0292 00). 2. Check windshield wiper motor for proper operation. 3. Turn windshield wiper switch OFF (see your -10). END OF TASK 0420 00-2 Change 1