TM-9-2350-247-20-3 Unit Maintenance Manual Volume 3 M548A1 M548A3 Tracked Cargo Carrier Download
Page 143 of 832
TM 9-2350-247-20-3 REPLACE WINCH (M548A1) — Continued 0407 00 INSTALLATION 1. Apply adhesive to a 2 x 4 inch (5 x 10 cm) area around two pairs of mounting holes where two new gaskets (1) will be mounted. Apply adhesive to 3 inch (8 cm) area where new gasket (2) will be mounted. Apply adhesive by one of the following procedures: a. Apply a thin, even coat of adhesive to each surface. Allow to dry completely. At installation, wet the surface with a clean cloth dampened in dry cleaning solvent. Press surfaces firmly together. b. Apply a thin, even coat of adhesive to both surfaces. Allow to dry until it is tacky but no longer transfers to finger when touched. This takes 10 to 20 minutes. (The higher the temperature, the shorter the drying time.) 2. Apply adhesive to both sides of two gaskets (1) and gasket (2). 3. Install two gaskets (1) on two pairs of mounting holes and gasket (2) on input shaft (3) on winch. 4. Apply adhesive to carrier surfaces that will be touched by two gaskets (1) and gasket (2). 5. Install key (4) on input shaft (3). 6. Reactivate adhesive on winch and carrier if listed above, is being used. 0407 00-5