TM-9-2350-247-20-2 Unit Maintenance Manual Volume 2 M548A1 M548A3 Tracked Cargo Carrier Download
Page 841 of 1072
TM 9-2350-247-20-2 REPLACE TORSION BAR — Continued 0349 00 NOTE Special socket head cap screw is used with adapter. 4. Thread special screw through adapter. NOTE Screw is installed with head inside adapter. 5. Thread adapter on slide puller, then thread adapter with screw into torsion bar. C A U T I O N When removing or installing torsion bars, the index or missing tooth on the anchor end of torsion bar must align with index on spline in road wheel arm, to allow bar to pass through. 6. Pull torsion bar (3) from torsion bar anchor (4). Use slide puller. 7. Remove slide puller and adapter from torsion bar. 8. If torsion bar (3) is broken, remove as follows: a. Remove road wheel end of torsion bar in the same way as unbroken torsion bar. b. Pull or drive end of broken bar from its splined seat in torsion bar anchor (4). 0349 00-3 Change 1