TM-9-2350-247-20-2 Unit Maintenance Manual Volume 2 M548A1 M548A3 Tracked Cargo Carrier Download
Page 430 of 1072
TM 9-2350-247-20-2 REPLACE GENERATOR DRIVE BELT ADJUSTING LINKAGE (M548A3) — Continued 0247 00 INSPECTION-ACCEPTANCE AND REJECTION CRITERIA 1. Inspect screw ends for damaged threads and turnbuckle and jam nut for dents and cracks. Replace turnbuckle assembly that shows any of these defects. INSTALLATION 1. Position eyebolt (1) of turnbuckle (2) end on generator (3) and secure with two washers (4), spacer (5), washer (6), and screw (7). 2. Position other eyebolt (8) of turnbuckle (2) end on shoulder pin (9) and secure with washer (10) and new cotter pin (11). 3. Loosen two generator mounting screws (12) and rotate turnbuckle (2) until drive belt deflection is 0.19-0.25 in (4.8-6.4 mm). Use V-belt tensiometer with a force of 15-17 lb (6.81-7.72 kg) and straight edge spanning both pulleys. Tighten jam nut (13) on turnbuckle (2). 4. Torque generator mounting screws (12) to 36-38 ft-lb (49-52 N•m). FOLLOW-THROUGH STEPS 1. Install power plant rear access panel (see your -10). END OF TASK 0247 00-2