TM-9-2350-247-20-2 Unit Maintenance Manual Volume 2 M548A1 M548A3 Tracked Cargo Carrier Download
Page 416 of 1072
TM 9-2350-247-20-2 REPLACE 100 AMP GENERATOR (M548A1) — Continued 0242 00 INSTALLATION NOTE Fill gaps between generator mounting lugs with shim washers before tightening screws and nuts. This will prevent damage to generator. 1. Place key (1) in generator shaft slot. 2. Install sleeve bushing (2) and pulley (3) on generator (4) shaft. Secure with three washers (5) and screws (6). Torque screws to 73-79 lb-in (8-9 N•m). 3. Place generator (4) with pulley (3) installed, on generator mount (7). Secure with three cap screws (8) and new lock nuts (9). 4. Connect wiring harness (10) to generator (4). FOLLOW-THROUGH STEPS 1. Connect battery negative lead (WP 0292 00). 2. Install generator drive belts (WP 0240 00). 3. Adjust generator drive belts (WP 0241 00) 4. Start engine (see your -10). 5. Check generator output for proper operation. 6. Stop engine (see your -10). 7. Install power plant rear access covers/door (see your -10). END OF TASK 0242 00-2