TM-9-2350-247-20-2 Unit Maintenance Manual Volume 2 M548A1 M548A3 Tracked Cargo Carrier Download
Page 400 of 1072
TM 9-2350-247-20-2 REPLACE DRIVE SHAFT LUBRICATION HOSE, FITTINGS, AND BEARINGS (M548A1) — Continued 0237 00 REMOVAL NOTE Normally, removal of all tubes, hoses, and fittings is not required to perform maintenance. Remove only those tubes, hoses, and fittings necessary to perform required maintenance. Leave clamps on tubes and hoses unless tube or hose is being replaced. 1. Remove two grease fittings (1) from block. 2. Disconnect hose (2) from adapter (3) and adapter (4) mounted on front bearing (5). 3. Remove screw (6), lock washer (7), clamp (8), and hose (2) from weld nut. Discard lock washer. 4. Remove adapter (4) from front bearing (5). 5. Remove two screws (9), nuts (10), and rear bearing (13), if required. 6. Remove adapter (3) from block. 7. Disconnect hose (11) from adapter (12). 0237 00-2